Discussion on Bullets and Bullet Lubes, Casting, Swaging, Paper Patching, and Lube Cookies.
4 posts • Page 1 of 1
I purchased this mould, stated to be for the Werder 11.5x35R and can´t make out how it´s expected to work as it can be filled from the top AND the bottom. Any ideas on how it was meant to be used? Could there have been a plug for one of the two filler holes that is now missing?
- P1020146.jpg (105.54 KiB) Viewed 2522 times
- P1020145.jpg (80.31 KiB) Viewed 2522 times
- P1020143.jpg (76.89 KiB) Viewed 2522 times
- PostsCOLON 1690
- JoinedCOLON Sun Nov 20, 2005 9:12 pm
- LocationCOLON the most boring real estate west of Illinois
It does look a bit curious. I believe if had a plug in the nose for making a hollow point. Alternatively, it could have had a plug in the base for making a hollow base bullet but I think the nose is more likely. either way, it leaves a hell of a sprue to contend with.
I'm not from here, I just live here.
Wonder whether it´d be possible to fit the two plugs before the metal hardened. But plugs are the only solution I can come up with (the Werder bullet had a hollow base).
Perhaps it was nose pour and the hollow base plug doubled as an alignment pin to hold it under the lead spout. I have cast Minnie style bullets and the. Plug it a time waster taking it out and replacing it. If the base plug was a fixed item under the lead spout you could pull the mould and just open it letting the bullet drop away.