A 330-grain mould for a .40-63 Ballard?

Discussion on Bullets and Bullet Lubes, Casting, Swaging, Paper Patching, and Lube Cookies.
Oregon Bill
PostsCOLON 85
JoinedCOLON Sun Nov 19, 2006 11:43 am
LocationCOLON Alamogordo, NM

A 330-grain mould for a .40-63 Ballard?

Post by Oregon Bill » Mon Jan 09, 2017 5:05 pm

I am in the midst of a deal for a Ballard in this chambering. The 1:20 twist precludes a heavier bullet, so thought I would try to duplicate the original, which had a good reputation. Anyone out there running a 330-grain .412? Where'd you get your mold?

BUTTON_POST_REPLY