Storing molds while still full.

Discussion on Bullets and Bullet Lubes, Casting, Swaging, Paper Patching, and Lube Cookies.
Singleshot S.A.
PostsCOLON 81
JoinedCOLON Sun Aug 30, 2015 6:19 pm
LocationCOLON Adelaide. Sth Oz.

Storing molds while still full.

Post by Singleshot S.A. » Mon Apr 23, 2018 10:10 pm

Does any one here store their molds away with a projectile still in the mold. ?

I don't, but the question was raised at the Club last week.

What would the advantage / dis advantage be ?

Brent
PostsCOLON 1572
JoinedCOLON Sun Nov 20, 2005 9:12 pm
LocationCOLON the most boring real estate west of Illinois

Re: Storing molds while still full.

Post by Brent » Tue Apr 24, 2018 5:20 am

I usually do not. I don't see an advantage unless someone things that it would reduce the air in the mould and thus the humidity. But since I don't have a problem with empty moulds, I don't see the advantage.
I'm not from here, I just live here.

beltfed
PostsCOLON 274
JoinedCOLON Tue Nov 29, 2005 4:02 pm
LocationCOLON WI

Re: Storing molds while still full.

Post by beltfed » Sun May 06, 2018 6:56 am

I have had best luck over the last 60+ years of casting to keep my 80+ molds in
GI ammo cans (with Good lid gasket) between casting. No bullets left in cavities.
I also have a few pieces of VPI rust inhibitor paper in the cans.
The molds go back into the cans soon after they cool down.
NO lube, etc spray necessary to keep them perfect and ready for nest casting run
Have never had any rust problems
beltfed/arnie

rfd
PostsCOLON 26
JoinedCOLON Fri May 01, 2015 4:39 pm
LocationCOLON nor'east
CONTACTCOLON

Re: Storing molds while still full.

Post by rfd » Mon May 14, 2018 6:10 pm

i don't like dealing with oil removal before casting and i am concerned with what humidity can do to steel. if the mould is stored full up, that does nothing for it's exterior. so ... after cool down, i wrap the mould tight with "press 'n' seal" - works quite well.

BUTTON_POST_REPLY

Who is online

Users browsing this forum: 1 and 0 guests