buttplate

Post your projects and questions here.
BigOtto
PostsCOLON 26
JoinedCOLON Sat Aug 09, 2008 8:25 am
LocationCOLON MN

buttplate

Post by BigOtto » Sat Mar 22, 2014 8:14 am

Still working on the Trapdoor Hawken, fitting the buttplate is tedious. This is my first attempt at a curved plate, the stock was pre-carved but the plate was far from exact fit. Heat and reshape the plate but still lots of wood to remove in very small bits using inletting black and files.

Image
***************************************

You gonna pull them pistols or whislte dixie?

BUTTON_POST_REPLY