Front tang screw for Pedersoli Sharps Silhouette model

Post your projects and questions here.
horseman308
PostsCOLON 35
JoinedCOLON Wed Aug 09, 2006 1:29 pm
LocationCOLON Maryland

Front tang screw for Pedersoli Sharps Silhouette model

Post by horseman308 » Sat Dec 01, 2018 8:41 am

I put Lee Shaver sights on my 74 Sharps. It's got that issue where the original tang screw is too long when used under the sight mounting plate, and interferes with the triggers. The screw was shortened some, but I wonder how much it should be shortened. When operating the triggers with the sight removed) I can see the screw actually move in its hole when setting and firing the triggers. I assume this is not correct?

Also, I need to replace the front tang screw. I buggered up the slot and would rather start with a new screw.
VTI Gunparts lists that screw but only shows a straight stock diagram and does not differentiate whether that screw will fit the pistol grip stock. Is it the same screw for both stocks? VTI has not responded to an email. Is there a better source for that screw? Thanks
The only bullet you fire is the one in the chamber. Make it count.

BUTTON_POST_REPLY